Dryer Sensor Catch-Up
Sukup TM3217 mixed-flow. Enter the unload speed and see how long corn going in the top takes to reach the moisture sensor at the bottom.
Unload speed
Speed changes
Each change below shows whether the corn that went in when you made it has reached the sensor yet. Use the fields to add a change you made earlier. 0% means the dryer was stopped.
Dryer numbers
From Sukup's TM3217 EXNO 2017-2023 (25:1 gearbox) drying-rate chart, dated 10/16/2025: 3,823 bu/hr at 100%, straight-line with percent (10% = 382 bu/hr), and 4,343 bu overall holding (3,307 bu in the heat section). Its turnover table reads 68 min at 100%, 136 min at 50%, 682 min at 10%. Sukup calls the time to unload the whole dryer one "turnover" and says to allow at least a third of a turnover between speed changes, adjusting about 3% per point of moisture you are off. If your dryer is an expandable model it holds more, so raise the holding number.
The math: minutes = holding ÷ (% × 60 bu/hr) × 60. Corn moves through the dryer in order, so corn going in now gets to the bottom once the whole holding volume has been unloaded behind it. Sukup's chart numbers are approximate and vary with flow gate settings, hybrid, and fines.